Photovoltaic panel clamp installation tutorial

Where should clamps be connected to the PV module?

When the mechanical load pressure is ±2400Pa, Clamps should be connected to the module between 400 and 500mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *NOTE: We need two or three support rails below the PV module to make sure the module have a good mechanical load performance.

How to install a PV module?

Remove the bottom connector parts. Connector parts : M8 Nut 、spring washer and washer. Put the clamp bolts into the installation holes, and then tighten the nuts. Insert the PV module into the clamp, and then tighten the nut. M8 ss304(16N· m~20N· m) Insert clamp into the connector racking.

How to install Trina Solar module with frameless clamps?

Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *Note: Need two support rails below the PV module to make sure the Mechanical load.

How do you mount a solar panel?

Seal the deal with module clamps. Clamp your solar panels on the mounting rails to create a single, solid system that can endure the harshest weather conditions. See also: Ground Mount Solar Panels (Advantages) “An ounce of prevention is worth a pound of cure,” they say.

Which Racking clamps should I use for Trina Solar racking?

For C structure steel type 1 racking, due to the amount of space inside the racking section, many choices are available including T-shape nuts. Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module.

How do I install a double glass PV module?

Insert the PV module into the clamp, and make sure the module edge touch to the EPDM closely and then tighten the nut with uniform torque values using a qualified torque wrench to ensure the double glass module is firmly secured. Trina suggests using M8 bolts to affix the double glass modules onto the clamp.