How to remove photovoltaic panels from the pallet

How to remove a pallet from a carton?

a forklift to separate the of modules to avoid the car-two pallet modules. ton turned over due to the strong wind and accidental collision. Cut off the packing tape of the single pallet , remove the isolated wood ( or plastic wrap ) and the carton cover. Remove remaining modules from the carton sequentially.

How do you take out a pallet?

Cut off the whole packing belt of the pallet, and use a forklift to separate the two pallet modules. When each of the modules is taken out in turn, lift up the EVA card slot on the top to ensure that the remaining modules are still in a fixed state, and then take out all modules in turn.

How do you separate a pallet?

Remove the first module labeled "1" from the opening position (marked in red) firstly. Cut off the whole packing belt of the pallet, and use a forklift to separate the two pallet modules.

How do you open a single pallet?

Cut off the packing tape of the single pallet , remove the isolated wood ( or plastic wrap ) and the carton cover. Remove remaining modules from the carton sequentially. Remove the first module labeled "1" from the opening position (marked in red) firstly.

How to transport solar panels?

Usually, to transport solar panels, a pallet is used. Here is how a good company packs it: • First panels go on the pallet bottoms up and the last one is placed front side up. • Corner protectors and foam pads across the frame are added. • Usually a piece of cardboard or plastic is placed in between every two panels.

How do you pack solar panels horizontally?

When solar panels are packed horizontally, unpacking the pallet is straightforward: cut the safety ribbons and take panels from the pallet one by one. Some manufacturers pack the panels horizontally though. In this case, if just remove the ribbons, the stack may just fall.