Remove the energy storage device from the power distribution cabinet

Can a power distribution cabinet be removed from the installation site?

If wires come in through the bottom side of the Power Distribution Cabinet and the side pan- els cannot be removed from the installation site (such as combined cabinets), first remove the wire cover at the bottom before moving the Power Distribution Cabinet to the installation site as follows:

What should I do if my power distribution cabinet is energized?

yWhen operating the Power Distribution Cabinet in an energized state, please use safety devices (such as insulating gloves and shoes) and operate on an insulating rubber cush- ion to avoid electrical shock. There should be at least one person to give assistance. In case of an accident, you should be adaptable and seek assistance.

How do I shut down the power distribution cabinet?

In case of emergency, you must shut down the Power Distribution Cabinet using the REPO Function. Please activate the switch of the remote device, then the main input circuit breaker will trip and stop all switchboard output. Triggering the switch again will make the Power Dis- tribution Cabinet revert to its normal operating condition.

How does the power distribution cabinet work?

The Power Distribution Cabinet provides two smart slots that allow you to connect the SNMP card, or use RS232 interface to connect to the work- station. The six built-in dry contacts allow you to connect an external device. Infrasuite Power Management7 2.6 Appearance 2.6.1 Appearance of the Cabinet (Figure 2-1: Appearance)

How to check the status of a power distribution cabinet?

The LCD monitor of the Power Distribution Cabinet can display the current system status and event logs, and allows you to set and view parameters. If the back light is not lit, pressing any button will activate it. On the initial status screen, you can view the system date and time as well as the switch- board circuit breaker status.

How do I remove the side panels of the power distribution cabinet?

If the space for installation allows, you can temporarily remove the side panels of the Power Distribution Cabinet for easy installation. Please see the following instructions: 1Remove the key attached to the front door and use it to unlock the side panels. 2To remove a side panel, hold on the handles on both sides, and then pull them up.