JinkoSolar 550 PV Panel Parameters

Where should Jinko Solar PV modules be installed?

2.2.2 Site Selection In most applications, Jinko solar PV modules should be installed in a location where they will receive maximum sunlight throughout the year. In the Northern Hemisphere, the module should typically face south, and in the Southern Hemisphere, the modules should typically face north.

Can JinkoSolar PV modules be installed in permanent shading conditions?

Operation in permanent shading conditions is not recommended. Do not install the PV module near open flame or flammable materials. JinkoSolar PV modules have passed the IEC 61701 salt spray corrosion test (test method 6). PV modules can be installed at a distance of 50m away from the seashore.

Do JinkoSolar PV modules pass the salt spray corrosion test?

JinkoSolar PV modules have passed the IEC 61701 salt spray corrosion test (test method 6). PV modules can be installed at a distance of 50m away from the seashore. In the case when the modules are installed within 50m to 500m distance from the seashore, the connectors shall be protected, i.e., adding dust plugs.

Does Jinko Solar withstand wind and snow?

Certified to withstand: wind load (2400 Pascal) and snow load (5400 Pascal). 0.55% annual power degradation and 25 year linear power warranty. ©2020 Jinko Solar Co., Ltd. All rights reserved. Specifications included in this datasheet are subject to change without notice.

Why should you choose Jinko Solar?

High salt mist and ammonia resistance. Optimized electrical design and lower operating current for reduced hot spot loss and better temperature coefficient. Certified to withstand: wind load (2400 Pascal) and snow load (5400 Pascal). 0.55% annual power degradation and 25 year linear power warranty. ©2020 Jinko Solar Co., Ltd. All rights reserved.

How much pressure does a Jinko module need?

When the modules are installed on the roof, they must be separated from the roof by more than 10cm to facilitate air circulation and heat dissipation. This design load was then tested with a safety factor of 1.5 times. So Jinko modules are tested under a maximum downward pressure of 5400Pa and upward pressure of 2400Pa.