Curtain wall solar panel bracket installation diagram

How do you install a curtain wall sill?

Check with the general contractor where to start the height of the sill for finished floor level. Installation typically starts with a vertical mullion at one end of the curtain wall assembly (If the unit has a corner, start at the corner). Following the shop drawing set the floor bracket flush with the outside wall.

How to install a curtain wall?

and windows for large openings. Curtain Wall installations are complex and should not be attempted wi on.Pre-Installation Site CheckYou must work from the provided ings to prepare the opening. The rough opening is the ect size, plumb and square. Verify that the concrete or sub-floor where the sys

How do I install a curtain wall Mullion?

Installation typically starts with a vertical mullion at one end of the curtain wall assembly (If the unit has a corner, start at the corner). Following the shop drawing set the floor bracket flush with the outside wall. Note: The gasket rubber attached to the vertical mullion must be outside of the rough opening for standard drainage.

How do I install a drainage line on a curtain wall?

opening for standard drainage. Once in place and plumb, snap a line flush with the interior of the curtain wall to the other end of the rough opening. Make sure the distance between the line and the outside w

How do you install a mullion bracket?

Make sure the distance between the line and the outside wall is consistent on both sides. Once the first mullion (or corner piece) is in place and plumb level, fasten the bracket using either flathead or concrete screws (depending on surface) straight into the bracket holes.

How do you install a pressure plate on a glass panel?

il flush with the glass face. Fasten the small temporary pressure plates at a vertical mid-point of the glass panel, using the essure plate screws provided. Screw in to the aluminum “V-Dent” located at center of the rubber gasket. Continue with the next vertical glass panel above first