Fengjun generator belt installation

How do you tighten a fan belt?

Tighten the locking nut or bolt and the lock washer to 455ft-lb (61bm) of torque so that the tensioner or bracket is fastened. 1. Loosen the large locking nut on the fan hub or fasten the fan hub to the bolt on the mounting bracket. After this work is done, the fan hub will deviate. 2. Turn the adjusting bolt to increase the tension of the belt. 3.

How do I change the timing belt on my tkdv6?

Refer to the TKDV6 Repair Manual (TK 55810). Install the new timing belt. Position the belt, the reference number on the belt should be between the injection pump pulley (iii) and the camshaft pulley (ii). Start at the crankshaft pulley (0). From (0) work the belt up and around pulley (i).

How do I fix a worn belt?

4. Belt tensioning is shown in the reading table 1 on the tensometer used. 5. Tighten the lock nut to 400, 450 feet-pound; then loosen back 1 / 2 laps. 6. Recheck belt tensioning. 7. Loosen adjustment bolt back to half ring to prevent damage. If the belt is worn or damaged, it should be replaced as follows. 1.

How do you tighten a belt tensioner?

Adjust the tension wheel with a pry rod or adjusting bolt until the tensometer indicates the appropriate belt tensioning. 3. Tighten the locking nut or bolt and the lock washer to 455ft-lb (61bm) of torque so that the tensioner or bracket is fastened.

How often should a HSG belt be replaced?

Here in Canada it gets inspected every 8,000 kms and replaced at 104,000 kms or 48 months on the HEV. Much more reasonable than 48,000 or 24 months for the PHEV. Sailormann, I'm also in Canada and the maintenance schedule on Hyundai Canada's website for our 2022 Tucson HEV is scheduled to have the HSG belt replaced at 48,000km.